Configure E-Mail Linkage; Trigger Alarm Outputs; Configure Ptz Linkage - HIKVISION DS-9600NI-I8 Series User Manual

Go to System > Network > Advanced > More Settings.
Set the alarm host IP and alarm host port.
Go to the Linkage Action interface of the alarm detection (e.g., motion detection, video
tampering, face detection, etc.).
Select the Notify Surveillance Center.

Configure E-mail Linkage

The system can send an email with alarm information to a user or users when an alarm is
detected.
Please refer to Chapter 15.7 Configure Email for details of Email configuration.
Go to System>Network>Advanced.
Configure the e-mail settings.
Go to the Linkage Action interface of the alarm detection (e.g., motion detection, video
tampering, face detection, etc.).
Select the Send Email alarm linkage action.

Trigger Alarm Outputs

The alarm output can be triggered by the alarm input, motion detection, video tampering
detection, face detection, line crossing detection, and any all other events.
Go to the Linkage Action interface of the alarm detection (e.g., motion detection, face detection,
line crossing detection, intrusion detection, etc.).
Click the Trigger Alarm Output tab.
Select the alarm output (s) to trigger.
Go to System> Event>Normal Event>Alarm Output.
Select an alarm output item from the list.
Refer to Chapter 11.6.3 Configure Alarm Output for the alarm output settings.

Configure PTZ Linkage

The system can trigger the PTZ actions (e.g., call preset/patrol/pattern) when the alarm event, or
VCA detection events occurs.
Make sure the connected PTZ or speed dome connected supports PTZ linkage.
Network Video Recorder User Manual
128