HIKVISION DS-9600NI-I8 Series User Manual page 31

Checks checkbox
Play or pause video in Playback mode
Advance video a single frame in single-frame Playback mode
Stop/start auto switch in auto-switch mode
13 PTZ Enter PTZ Control mode
Go back to previous screen
14 ESC
N/A
15 RESERVED Reserved
Select all items on a list
16 F1 N/A
Switch between play and reverse play in Playback mode
17 PTZ Control Adjust PTZ camera iris, focus, and zoom
Cycle through tab pages
18 F2
Switch between channels in Synchronous Playback mode
Troubleshooting Remote Control:
Make sure you have installed batteries properly in the remote control. And you have to aim the
remote control at the IR receiver in the front panel.
If there is no response after you press any button on the remote, follow the procedure below to
troubleshoot.
Go to System > General by operating the front control panel or the mouse.
Check and remember device ID#. The default ID# is 255. This ID# is valid for all the IR remote
controls.
Press the DEV button on the remote control.
Enter the device ID# you set in step 2.
Press the ENTER button on the remote.
If the Status indicator on the front panel turns blue, the remote control is operating properly. If
the Status indicator does not turn blue and there is still no response from the remote, please
check the following:
Network Video Recorder User Manual
30