Festo CPX-FB13 Electronic Manual page 21

1. Installation
Fitting
Festo P.BE-CPX-FB13-EN en 0112NH
Fit the field bus node as follows:
1. Place the field bus node in the manifold sub-base. Make
sure that the grooves with the contact terminals on the
bottom of the field bus node lie above the contact rails.
Then push the field bus node carefully and without tilting
as far as possible into the manifold sub-base.
2. Tighten the screws only by hand. Place the screws so that
the self-cutting threads can be used.
Tighten the screws with a Torx screwdriver size T10 with
torque 0.9...1.1 Nm.
1-7