Festo CPX-FB13 Electronic Manual page 110

A. Technical appendix
Octet Designation
2 and 3 WD_Fact_1
WD_Fact_2
4 Minimum station delay
responder (min T
5 and 6 Ident_number
7 Group_Ident
8...198 User_Prm_Data
Tab. A/2: Further octets
A-6
Further octets
Explanation
Range 1...255: The response monitoring time of the
CPX terminal is transmitted with these two octets:
TWD [s] = 10 ms x WD_Fact_1 x WD_Fact_2
The minimum time the CPX terminal must wait,
) before the reply telegram may be sent to the DP
SDR
master.
Transmit the Ident. number (= 059E
terminal; parametrizing telegrams to the CPX ter-
minal are only accepted if the transmitted and the
programmed Ident. numbers are the same.
Not supported by the CPX terminal
Information on the slave-specific parameters can be
found in the section 2.2 and the CPX system manual
P.BE-CPX-SYS-.. as well as in the manual for the I/O
modules P.BE-CPX-EA-.. .
) of the CPX
H
Festo P.BE-CPX-FB13-EN en 0112NH