Maintenance; Cleaning By The Operator; Cleaning The Label Sensor - CAB hermes+ Service Manual

3

Maintenance

3.1

Cleaning by the Operator

The following cleaning work is described in the "Operator's Manual":
• Cleaning the device
• Cleaning the printhead
• Cleaning the print roller
3.2

Cleaning the Label Sensor

1
Figure 1 Cleaning the label sensor
Danger!
Risk of death via electric shock!
 Before opening the rear cover, disconnect the device from the mains supply and wait at least one
minute until the power supply unit has discharged.
1. Unplug the printer from the electrical outlet and remove the rear cover.
2. Remove the material from the printer.
3. Unplug the male connector (2) of cable (1) from the female connector of the label sensor (3).
4. Loosen screw (7) and pull out of the profile (4) the label sensor (3) with spindle (5) and the cover (6).
5. Clean label sensor (3) with a brush or a cotton swab soaked in pure alcohol.
6. Move the label sensor (3) with spindle (5) and cover (6) into the profile (4) in the former position.
7. Fix the assembly with screw (7).
8. Plug in the connector (2) from cable (1) on the label sensor (3).
9. Mount the cover and restore all connections.
10. Adjust the label sensor  Operator's manual.
2 3
4 3 5 6
7
7