Reel Lapping - Toro Reelmaster 5100-D Service Manual

Reel Lapping

DANGER
Reel may stall while backlapping. Do not at-
tempt to restart reels by hand or ad ust while
backlapping. Stop engine and turn H.O.C.
knob one position toward "A".
1. Put the machine on a clean, level surface, lower
cutting units, stop the engine, engage the parking
brakes, move the enable/disable switch to
remove key from ignition switch (Fig. 20)
2. Unlock and raise seat to expose controls.
3. Open control cover and turn the height of cut selection
knob to position "P".
4. Make initial bedknife to reel adjustment for backlap­
ping on all cutting units.
5. Start engine and run at
DANGER
To avoid personal injury, never put hands or
feet in reel area while engine is running.
Changing reel speed while backlapping may
cause reels to stall. Never change engine
speed while backlapping. Only backlap at en ­
gine idle speed. Never attempt to turn reels by
hand or with foot while engine is running.
6. Move backlap switch to either
select with reels are to be backlapped.
DANGER
To avoid personal injury, make sure you are
clear of cutting units before proceeding.
7. Move enable/disable switch to
mow/raise lever forward to start backlapping operation
on selected reels (front or rear).
Repairs
j
and
DISABLE
.
IDLE SPEED
or
FRONT REAR
. Move lower
ENABLE
1
1. Height of cut (H.O.C.) selector knob
to
1
Page 8 - 16
2
1
Figure 20
1. Enable / Disable switch
2. Lower Mow / Raise control lever
Figure 21
Figure 22
1. Backlap switch
®
Reelmaster 223-D/5100-D/5300-D