Toro Reelmaster 5100-D Service Manual page 171

Condition
_________________________________________________________________________________________
Cutting units run, but should not,
when raised and do not shut off
with Enable/Disable switch.
_____________ ________________ ______ ________________ ______ ________________ __________________________________ __ __
Cutting units run, but should not,
when lowered with Enable/
Disable switch in disable position.
_____________ ________________ ______ ________________ ______ ________________ __________________________________ __ __
No cutting units operate in either
direction (raise and lower
function OK).
®
Reelmaster 5100-D
Possible Cause
Both the front reels down sensor
and enable switch circuits are
closed.
Hydraulic problem.
__ __ __
Enable/Disable switch circuit
closed.
__ __ __
Seat lifting off seat switch.
Seat switch circuit open.
Enable/Disable switch circuit open.
Front reels down sensor circuit
open.
Solenoid problem.
Hydraulic problem.
Page 5 - 13
Correction
Check front reels down sensor
and enable switch and replace if
necessary.
Check wiring to both switches
and repair if necessary.
See Troubleshooting section of
Chapter 4 - Hydraulic System.
__
Test Enable/Disable switch and
replace if faulty.
Check Enable/Disable switch
wiring and repair if faulty.
__
Instruct operator to sit back in
seat during operation.
Check seat plate hinges and seat
support pin and repair if faulty.
Check seat switch and replace if
faulty.
Check seat switch wiring and
repair if faulty.
Check Enable/Disable switch and
replace if faulty.
Check Enable/Disable switch
wiring and repair if faulty.
Check front reels down sensor
and replace if faulty.
Check front reels down sensor
wiring and repair if faulty.
Test solenoid and replace if faulty.
Check wiring to solenoid and
repair if necessary.
See Troubleshooting section of
Chapter 4 - Hydraulic System.
__
___ ______________________________
___ ______________________________
Troubleshooting