Rear Axle Removal And Installation - Toro Reelmaster 5100-D Service Manual

Rear Axle Removal and Installation

0.032"
1. Remove drive shaft (see Drive Shaft Service).
2. Thoroughly clean around hydraulic hoses connec-
tions to steering cylinder. Mark hoses so they will be
installed correctly during reassembly. Disconnect hoses
from fittings on steering cylinder. Put plugs or caps on
open hoses and fittings to prevent contamination of
hydraulic system.
3. Loosen rear wheel capscrews (Item 39).
4. Block front tires and jack up rear of machine until there
is approximately one inch clearance between rear tires
and the ground. SECURELY BLOCK FRAME.
5. Remove rear wheels and wheel spacers (Item 41).
Repairs
0.318"
0.018"
"
0.018
Figure 10
6. Remove capscrew (Item 4) from pin (Item 44). Re ­
move pin (Item 44) from axle support, allowing axle to
be lowered to floor and removed.
7. Reverse steps 1 - 7 to install axle.
Install washers (Items 14, 15, 43) between axle and
axle support.:
Apply medium strength locktite to capscrew (Item 4)
before installing to secure pin (Item 44).
NOTE: To hold wheel spacer (Item 41) on hub when
installing wheel, apply a small amount of grease to hub
side of spacer before putting into position on hub.
Page 9 - 8
Apply Loctite
Item 14 (qty. 2) is 0.018" thick.
Item 15 is 0.318" thick.
Item 43 is 0.032" thick.
Reelmaster
45 - 55 ft-lb
®
223-D/5100-D/5300-D