Compression Test - Toro Reelmaster 5100-D Service Manual

Compression Test

Normal cylinder compression is 28 kg/cm
280 rpm (normal cranking speed). The engine should
be warm - coolant temperature of 50
IMPORTANT: DO NOT put oil into the combustion
chamber before performing a compression test.
Damage may result because of "hydraulic" forces
acting upon the piston and connecting rod.
1. Remove the glow plug lead wires and glow plugs from
all three cylinders.
2. Insert the compression gauge adapter into the glow
plug hole. (See the Special Tools section of this chapter.)
3. Connect the high pressure compression gauge to the
adapter (Fig. 16).
4. Disconnect the fuel stop solenoid electrical connector
to prevent fuel delivery during the compression test
(Fig. 17). This will prevent wash-down of the cylinders
and inaccurate readings.
5. Crank the engine with the starter motor until you get
a stable gauge reading.
6. Normal compression is 28 - 32 kg/cm
If the pressure is less than 25 kg/cm
necessary to find the cause of low compression. (See
Engine Fails to Start - Low Compression in the Trou­
bleshooting section of this chapter.)
7. Repeat the test for the other two cylinders. Difference
between cylinders should be no more than 2.5 kg/cm
(36 psi).
8. Connect the fuel stop solenoid electrical connector.
®
Reelmaster 223-D/5100-D
2
(398 psi) at
o o
C (120 F).
2
(398 - 455 psi).
2
(356 psi) it will be
2
Page 3 - 19
Figure 16
Figure 17
1. Fuel stop (ETR) solenoid electrical connector
1
Testing