Check The Planetary Gear Drive Oil; Check The Tire Pressure; Check Reel-To-Bedknife Contact - Toro REELMASTER 6700-D Operator's Manual

CHECK THE PLANETARY GEAR DRIVE
OIL (Fig. 7)
Check the oil if external leakage is noted. Use high-quality SAE
85W-140 wt. gear lubrication as replacement.
System capacity is 47.3 cl.
1. With the machine on a level surface, position the wheel so
the check/drain plug is at either three or nine o'clock posi-
tion.
2. Remove the plug. Oil should be to the bottom of the hole.
3. Add gear oil, if necessary, to bring fluid up to the correct
level and install the plug.
4. Repeat steps 1–3 on the opposite gear assembly.
CHECK REAR AXLE LUBRICANT
The rear axle is shipped from the factory filled with SAE 85W-
140 wt. gear lubrication. Check the level before the engine is
first started and every 400 hours thereafter. Capacity is 2.3 l.
Visually inspect for leaks daily.
1. Position the machine on a level surface.
2. Remove a check plug from one end of the axle and make
sure lubricant is up to bottom of hole. If the level is low,
remove the fill plug and add enough lubricant to bring the
level up to the bottom of the check plug holes.
CHECK TIRE PRESSURE
The tires are over-inflated for shipping. Therefore, release some
of the air to reduce the pressure. Correct air pressure in the front
and rear tires is 103–138 kPa.
IMPORTANT: Maintain even pressure in all tires to assure
a good quality-of-cut and proper machine performance. DO
NOT UNDER INFLATE.
CHECK REEL-TO-BEDKNIFE
CONTACT
Each day before operating, check reel-to-bedknife contact,
regardless of whether the quality of cut had previously been
acceptable. There must be light contact across the full length of
the reel and bedknife (refer to Adjusting Reel to Bedknife in
Cutting Unit Operator's Manual).
Figure 7
1. Check/Drain plug
Figure 8
1. check plug
2. Fill plug
13