Installation Of Torque Spring Set - Toro Reelmaster 5100-D Service Manual

Installation of Torque Spring Set

IMPORTANT: Torque spring set adjustment has
been done and sealed at the factory. Do not remove,
disassemble or adjust this device unless necessary.
The torque spring set adjustment is very sensitive.
Improper adjustment can vary fuel delivery to under
power or over fuel the engine.
1. Engage the parking brake. Make sure the high speed
set bolt is adjusted to the correct engine speed of
+50
3200 rpm (See Adjusting Engine Speed in the
– 0
Maintenance section of this chapter).
NOTE: Specified rpm is with no load on engine.
2. Operate the engine at high idle speed.
3. Turn the torque spring set (Fig. 36) clockwise until
engine speed drops approximately 50 rpm from high idle
speed.
4. From this position, turn the back the torque spring set
(counterclockwise) "N" turns (2.8 turns). Lock the torque
spring set in position with the special nut.
5. Install the sealing cap.
Figure 36
®
Governor System Repairs Page 3 - 34 Reelmaster 223-D/5100-D