Cutting Units Raise, But Will Not Stay Up
Cause
_________________________________________________________________________________________
S6 energized (should only be energized during
lower function).
_____________ ________________ ______ ________________ ______ ________________ __________________________________
__
__
S6 leaking down (not seating properly).
Cutting Units Raise Too Fast or Too Slow
Cause
_________________________________________________________________________________________
One-way variable orifice not properly adjusted (cen-
ter and rear cutting units only) - see Hydraulic Sche
matics.
®
Reelmaster
5100-D
__
__
__
Page 4 - 23
Correction
Do electrical diagnostics. See Chapter 5 - Electrical
System.
__
Do cartridge valve service procedure for valve S6.
Replace S6 with a new valve if faulty.
Correction
Adjust variable orifice for affected circuit.
__
___
______________________________
__
Troubleshooting