Front Roller Adjustment - Toro Reelmaster 5100-D Service Manual

Front Roller Adjustment

Loosen four (4) capscrews holding front roller brackets.
Push roller towards the rear, then hold in position and
tighten capscrews. Make sure roller has not changed
position. NOTE: When securing front roller brackets,
tighten fastener on inside of cutting unit frame so posi­
tion of roller bracket does not change.
1
Figure 10
1. Roller bracket
®
Page 8 - 10 Rev. A
Set Up and Adjustments Reelmaster 223-D/5100-D/5300-D