Toro Reelmaster 5100-D Service Manual page 224

10. Install the shim and snap ring onto the end of the
pinion shaft. Use the thickest shim possible which will
permit installation of the snap ring (Fig. 44). Limit the
end play to 0.000 - 0.005 inch (0.000 - 0.127 mm).
11. Apply a small bead of Permatex No. 2 or silicone
sealant to the outer edge of the carrier bore. Install the
expansion plug (or seal if equipped with pinion coupler
for 4WD) into carrier until plug or seal seats firmly in
carrier bore (Fig. 45).
12. Install the spur gear cover. Use Permatex No. 2 or
silicone sealant when installing the cover. Tighten the
capscrews to a torque of 25 - 40 in.-lb. (Fig. 46).
Repairs Page 6 - 18
Figure 44
Figure 45
Figure 46
®
Reelmaster 5100-D