Assembled Board, Front View; Jumper Settings - Intel 852GM User Manual

Installation Guide for POC Board
Table 3.

Jumper Settings

Jumper
J1
J2
J3
J4
J5
4. Verify installed hardware. Make sure the following hardware is populated on your POC
board:
•
One Onboard Intel
•
BIOS FWH
•
Battery
•
Heatsink
Note: If the above hardware is not installed correctly, DO NOT apply power to the board.
Correctly re-install the components before proceeding.
5. Install memory. Install the SO-DIMM in memory slot DIMM1. Insert the SO-DIMM above
the slot (the DIMM is keyed so that it only fits in the slot in one orientation). Firmly, but
carefully, insert the SO-DIMM into the slot until the tabs close.
Figure 3.

Assembled Board, Front View

12
Function
Clear CMOS
LCD Voltage Selection
COM2 RS-232/422/485 Mode Selection - 1
COM2 RS-232/422/485 Mode Selection - 1
COM2 RI/+5V/+12V Selection
® ®
Celeron M processor 1.3 GHz, mFCBGA479 package
®
Intel 852GM Small Form Factor Proof-of-Concept Board User's Manual
Default Setting
1-2 Normal
1-2 +5 V
1-2 RS232
1-2 RS232
5-6 RI