Table of Contents
Advertisement
Installation Guide for POC Board
2.1
Before You Begin
Table 2
represents the additional hardware you may require to set up the board.
Table 2.
Additional Hardware
Component
VGA Monitor
Keyboard
Mouse
IDE Devices
Network Adapter
AT Power Supply
Memory
Other Devices and Adapters
2.2
Setting up the SFF POC Board
Gather the hardware described in
manual assumes you are familiar with basic concepts of installing and configuring hardware for an
x86 architecture platform.
1. Ensure a static-free work environment. Static-free procedures must be completed before
removing any components from various anti-static packaging. The POC board is susceptible to
electrostatic discharge (ESD), which may cause product failure or unpredictable operation.
Warning:
Connecting the wrong cable or reversing a cable may damage the POC board and the device being
connected. Since the board is not in a protective chassis, use caution when connecting cables to this
product.
2. Verify contents. Inspect the contents of your kit and make sure that everything listed in
Section 2.1
3. Check jumper settings. Verify that the following jumpers are set in their default state (see
Table
®
Intel
852GM Small Form Factor Proof-of-Concept Board User's Manual
Standard VGA or greater resolution monitor
Keyboard with a PS/2 connector or adapter
Mouse with a PS/2 connector or adapter
Up to two IDE devices can be connected to the POC board. One cable is
included in this kit. The cable accommodates the included hard drive and one
other IDE device, such as a CD-ROM drive or another hard drive.
An Intel
CAT-5 cable with an RJ-45 connector is required to connect this Ethernet
adapter to local area network.
Require an AT power supply to power the board. If you are using ATX power
supply, some minor work is required.
Require one module of 200-pin DDR266 SODIMM (max 1 GB)
Many PC compatible peripherals can be attached and configured to work
with the POC board. For example, to install an additional network adapter
into the mini PCI slot. Procuring and installing any drivers required for
additional devices will need to be done by user.
Table 2
is included. Check for damage that may have occurred during shipment.
3).
Installation Guide for POC Board
Description
®
82562ET Ethernet Controller is included in the development kit. A
and follow the steps below to set up the POC board. This
2
11
Advertisement
Table of Contents
