Vsn Camera Cable - Raven VSN Installation Manual

For agco rogator c

Hide thumbs Also See for VSN:

Table of Contents

CHAPTER 3

VSN CAMERA CABLE

1. Route the end of the VSN camera cable (P/N 115-2020-007) with the round 35 pin connectors up through the

opening at the bottom of the area behind the exterior access panel.

2. Locate and disconnect the four round bulkhead connections labeled X3, X4, X5 and X6 to gain access to the

power connections and the X4 Cab #4 connection.

NOTE:

Label the bulkhead connectors to ensure proper re-connection.

FIGURE 12. Exterior Cab Access Panel

3. Locate the power connections and install the power ring terminal on the red power stud and the ground ring

terminal on the black ground stud.

4. Locate the X4 Cab #4 bulkhead and connector. Tee in the appropriate connectors of the VSN camera cable (P/

N 115-2020-007).

5. Reinstall the previously removed bulkhead connections.

6. Locate the round 7-pin connector labeled VIDEO on the VSN camera cable (P/N 115-2020-007) and connect it

to the bulkhead port installed in the previous section (refer to Figure 8 on page 15).

7. Route the gray 23-pin connector along the frame to the right boom cradle.

NOTE:

Be sure the cable is routed to prevent the cable from being pinched by the boom or other moving

components of the equipment.

8. Connect the 23-pin connector to the back of the VSN camera.

Remove 4 Bulkhead

Connections to gain

access to the X4 and

Power terminals

VSN Installation Manual for AGCO RoGator C

X4 Cab #4

Bulkhead

Table of Contents