Removing The Belt, Drum, And Rollers - Whirlpool WED9500E SERIES Service Manual

9.2 cu. ft. steam dryer
Table of Contents

Advertisement

COMPONENT ACCESS
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or
electrical shock.
To Remove the Belt and Drum
1. Unplug dryer or disconnect power.
2. Perform the procedures on page 4-4, "Removing the
Top Panel" and "Removing the Console/UI" prior to
performing the following steps.
3. Perform the procedures on page 4-6, "Removing the Front
Panel" prior to performing the following steps.
4. Remove front 1/4" hex-head screw securing the control
bracket to the console bracket...or remove the entire
control bracket (see Figure 1).
Front Control Bracket Screw
5. Remove the four (4) 1/4" hex-head screws from the front
console bracket and remove bracket (see Figure 2).
Console Bracket Screws
4-8
Whirlpool & Maytag 9.2 Cu. Ft. Steam Dryer
n

Removing the Belt, Drum, and Rollers

Figure 1
Figure 2
6. Disconnect Moisture Sensor connector (see Figure 3).
Moisture Sensor
Connector
7. Remove the four (4) 1/4" hex-head screws from the lint
duct as illustrated in Figure 4. Swivel the lint duct down
from the bulkhead and remove.
Figure 3
Swivel down and
remove lint duct.
Figure 4

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Medb955f seriesMgdb955f seriesWgd9500e series

Table of Contents