Ranger DST30P Installation And Operation Manual page 15

Installing the Control Panel
The Control Panel lets you control the Balancer; it also displays Balancer information.
Tip
To install the Display Panel:
1. Locate the Control Panel Mount Bar.
The Control Panel Mount Bar is a single unit that includes the Display at the top and a plate at the
bottom that attaches to the back of the Balancer.
2. Remove the four hex bolts, four split lock washers, and four standard washers that come installed
on the back of the Balancer.
The bolts and washers come installed around the hole in the back of the Balancer where you can
see the Control Panel Pins. Refer to the drawing on the previous page.
Keep the bolts and washers nearby; you will be putting them back very soon.
3. Put the plate at the bottom of the Control Panel Mount Bar next to the Control Panel Pins and hold
it there.
This is the part where it is best to have two people: one person to hold the Control Panel Mount
Bar in place and the second person to attach the white connectors and re-install the bolts.
4. Attach the Connectors, which are on the ends of the wires coming out of the bottom of the Control
Panel Mount Bar, to the Control Panel Pins, which are recessed on the back of the Balancer.
There are four wires, each with a white Connector on the end of the wire. Each connector has a
unique number of holes in it. These holes correspond to the Control Panel Pins.
Match the number of holes in the white Connector to the number of Control Panel Pins. When the
number of pins
For example, CN4 on the bottom row of the Control Panel Pins has
Connector that has
It may be necessary to adjust the wires to get the white Connectors into the right spot.
5. Push each white Connector in far enough so that you hear or feel it click into place.
The white Connector
6. Re-install the four hex bolts, four split lock washers, and four standard washers.
Tighten the bolts securely, but
Important:
DST30P Wheel Balancer
BendPak Ranger recommends having
person to hold the Control Panel Mount Bar in position and the other person to connect
the wiring and re-install the bolts and washers.
exactly matches
three holes
must click into place
do not overtighten
The plate at the bottom of the Control Panel Mount Bar includes a cover that
comes installed. This cover can be removed if necessary.
at least two people
the number of holes, connect them.
to CN4.
for the Control Panel to work correctly.
.
15
perform this step: one
three pins . Attach the white
P/N 5900163 — Rev. C1 — March 2020