Ranger DST30P Installation And Operation Manual page 16

Installing the Hood
Installing the Hood requires you to install three separate items, in this order:
• Install the Hood Mount Box on the back of the Balancer.
• Attach the Hood Mount Arm to the Hood Mount Box.
• Attach the Hood to the top of the Hood Mount Arm.
To install the Hood:
1. Locate the Hood Mount Box, the Hood Mount Arm, the Hood, and the bolts and washers needed
to install them:
– The Hood Mount Box comes in its own box that includes a bag with bolts, washers, and hex
wrenches.
– The Hood Mount Arm comes by itself, wrapped for shipping. There are two Set Screws already
in place next to the Hole at the bottom of the Arm and two hex head bolts in place at the top.
– The Hood also comes by itself, wrapped for shipping. It has a Rod on one corner that attaches
to the top of the Hood Mount Arm.
Starting with the Hood Mount Box
2.
Keep the screws nearby; you will be reinstalling them soon. Don't lose them, they are small.
3. Use the four bolts, washers, and split lock washers from the bag to connect the Hood Mount Box
to the back of the Balancer.
Tighten the four bolts securely.
Front not shown, for clarity. Not necessarily to scale. Not all components shown.
4. Attach the pins on the Hood Wiring to the Hood Connector coming out of the right side of the
Hood Mount Box.
The two pins go into the two holes in the connector. Make sure the connector and the pins click
into position.
5. When the wiring is connected, reinstall the top of the Hood Mount Box.
DST30P Wheel Balancer
, remove the top (four small black screws).
16
P/N 5900163 — Rev. C1 — March 2020