Ranger DST30P Installation And Operation Manual page 17

6. Locate the Hood Mount Arm and the Hood.
7. Starting with the
Shaft on the left side of the Hood Mount Box. The Shaft is shown in the drawing on the previous
page.
Orient the Hood Mount Bar so that the Bumper goes up against the back of the Balancer.
8. Align the Set Screws on the bottom of the Hood Mount Arm with the Grooves in the Shaft, then
tighten the Set Screws.
Important:
Not necessarily to scale. Not all components shown.
9. When the Set Screws are correctly installed, put the large washer and hex head bolt into place on
the end of the Shaft (the Hex Head Bolt Hole) and tighten the hex head bolt.
Switching to the
10.
washers.
They come from the factory in place at the top of the Hood Mount Arm.
11. Switching to the Hood
the Hood Mount Arm.
The Handle in the Hood should be at the front of the Balancer.
12. Replace the two hex bolts and split lock washers you just removed; tighten them securely.
13. Test the Hood to make sure it moves back and forth smoothly.
DST30P Wheel Balancer
of the Hood Mount Arm
bottom
The Set Screws need to be tightened down into the Grooves in the Shaft or the
Hood will not work correctly.
of the Hood Mount Arm
top
, put the Rod on one corner of the Hood into position next to the top of
, slip the hole at the bottom over the
, remove the two hex bolts and the split lock
17
P/N 5900163 — Rev. C1 — March 2020