Ranger DST30P Installation And Operation Manual page 12

Finding a Location
Keep in mind the following when deciding on a location:
• Power source. The Balancer needs to be near an appropriate power source.
• Floor. The Balancer is best used on a flat, concrete floor. If the floor is unstable or not flat, the
Balancer will not work correctly; the readings will not be right.
• Accessibility. You need some space to move the Wheels you are going to balance to and from
the Balancer.
• Danger. When a Wheel is spinning on the Balancer, you need to keep people away from it. Do
not set up the Balancer in a well-travelled area. Everyone except the Operator should be at least
30 feet away from the Balancer when it is in use.
• No water. The Balancer has electronic components. If the Balancer gets wet while turned on,
those electronic components will most likely short circuit and have to be replaced.
⚠
WARNING
Clearances
A certain amount of space around the Balancer is required.
You also need enough room
DST30P Wheel Balancer
Do not use the Balancer if it is sitting in water. You will almost certainly short circuit
the electronic components in the Balancer and you could electrocute yourself.
above
the Balancer for the Hood to move up and down freely.
12
P/N 5900163 — Rev. C1 — March 2020