Ranger DST30P Installation And Operation Manual page 33

When you press the + or – button under Width for the first time, the Inner Window changes from
–A– to –L– and displays the value 5.7 in the Outer Window.
The value in the Outer Window changes as you press the + and – buttons under Width.
14. When the Width value is correct, use the Calipers to measure the diameter of the Rim or read the
diameter off the Sidewall of the Tire.
15. Input the diameter using the + and – buttons under Diameter.
When you press the + or – button under Diameter for the first time, the Inner Window changes
from –L– to –d– and displays the value 14.0 in the Outer Window.
The value in the Outer Window changes as you press the + and – buttons under Diameter.
When the Diameter value is correct, you are done inputting measurements.
16. Lower the Hood; the Wheel spins briefly.
17. When the Wheel stops, lift the Hood.
The Inner Window shows the amount of Weight you need to add to the Center Plane for STA1 or
the Inner Edge for STA2.
The Outer Window shows the selected Balancing Mode, St.1 or St.2.
If the Inner window shows 00, the Wheel is balanced; no Weight needs to be added.
18. To add Weight, turn the Wheel, watching the indicators under the Inner Window.
The Indicators light up or go out as you move the Wheel.
19. When all of the Indicators go on, press the Brake Pedal to hold the Wheel at that position.
20. Add the Weight at Top Dead Center on the Wheel (12 o'clock high) at the appropriate location.
For STA1, add Weight to the Center Plane.
For STA2, add Weight to the Inner Edge.
21. When the Weight is added, release the Brake Pedal.
22. Lower the Hood to spin the Wheel again.
The Wheel is balanced when both the Inner Window shows 00.
It may take more than one time adding weights to get to 0.0 | 0.0.
DST30P Wheel Balancer
33
P/N 5900163 — Rev. C1 — March 2020