Ranger DST30P Installation And Operation Manual page 37

Switching Between Inches and Millimeters for Distance
You cannot do this.
Distance is
This means you can always use the values you see on the ruler and never have to make a conversion.
Switching Between Inches and Millimeters for Width
When you are entering measurements for a Wheel, you can have the values for Wheel Width display in
either Inches or Millimeters. The default is Inches.
To switch from Inches and Millimeters for Wheel Width measurements:
1. Turn the Balancer Off and then back On again using the On/Off Switch.
This sets the Wheel Width display setting back to the default, Inches.
2. Specify a Distance value.
3. Press the + or – button under Width.
-L- appears on the Inner Window and a value appears in the Outer Window.
The value in the Outer Window does not matter if you are just changing the display setting.
4. Press and hold the Stop button, then press the + and – buttons under Width.
You will hear a beep; the display changes from Inches to Millimeters.
5. To tell which setting is active, look at the values in the Inner and Outer Windows:
– If the values have decimal points, Inches are active.
– If the values
Note:
DST30P Wheel Balancer
always
measured in Centimeters, because the Ruler on the Inner Arm uses Centimeters.
do not
have decimal points, Millimeters are active.
The Inches/Millimeters setting for Wheel Width is
Instead, it resets to the default, Inches.
not
saved if you restart the Balancer.
37
P/N 5900163 — Rev. C1 — March 2020