Troubleshooting - Ranger DST30P Installation And Operation Manual

Troubleshooting

⚠
DANGER
Perform the following checks if you are experiencing balancing problems:
• Confirm the location and alignment of the alignment marks on the Shaft Assembly and Shaft
Housing (see
• Make sure the Balancer is anchored (see
• Perform a Weight Location Verification Test (see
information).
Perform the calibration with a steel Wheel of the most commonly used size.
Note:
Make sure the calibration weight used is a 100 gram or 3.5 ounce weight and that is mounted
correctly during the calibration procedure.
Issues
Issue
Nothing on the Display Panel.
The Balancer is not producing good
balances on a consistent basis.
Vibration persists after balancing.
If you continue to have problems with your Wheel Balancer, visit www.bendpak.com/support/,
call BendPak Ranger at (805) 933-9970, or email support@bendpak.com.
DST30P Wheel Balancer
Disconnect the Power Cord from power
troubleshooting procedures
sure the unit cannot be re-energized until Troubleshooting is over. Because the unit
uses electricity, you could be electrocuted or even killed if the unit is powered back
on during a Troubleshooting procedure. If your organization has Lockout/Tagout
policies, make sure to implement them before beginning any Troubleshooting.
Installing the Shaft
It is a good practice to keep a known good Wheel of the most commonly used size to
use as a calibration / reference tire to assist in troubleshooting.
before performing any
and take whatever steps are necessary to make
for more information).
Anchoring the Balancer
Weight Location Verification Test
Action to Take
Make sure the Balancer is turned on and getting power.
Perform a Dual-Plane Self-Calibration Procedure. Refer to
Dual-Plane Self-Calibration Procedure
information.
Perform a Weight Location Verification Test. Refer to
Location Verification Test
A weight has come off; replace it.
Tire is slipping on the Wheel (possible Tire Changer issue);
have Tire remounted and then rebalanced.
Stones or other objects caught in Tire tread; remove the
objects, rebalance if necessary.
40
for more information).
for more
for more information.
P/N 5900163 — Rev. C1 — March 2020
for more
Weight