Ranger DST30P Installation And Operation Manual page 35

The 8.0 is replaced by the value you enter. It goes up and down in small increments as you press
the buttons.
12. When the Distance value is correct, use the Caliper to measure the width of the Rim, Inner Edge to
Outer Edge.
13. Input the distance you measured using the Calipers using the + and – buttons under Width.
When you press the + or – button under Width for the first time, the Inner Window changes from
–A– to –L– and displays the value 5.7 in the Outer Window.
The value in the Outer Window changes as you press the + and – buttons under Width.
14. When the Width value is correct, use the Calipers to measure the diameter of the Rim or read the
diameter off the Sidewall of the Tire.
15. Input the diameter of the Wheel using the + and – buttons under Diameter.
When you press the + or – button under Diameter for the first time, the Inner Window changes
from –L– to –d– and displays the value 14.0 in the Outer Window.
The value in the Outer Window changes as you press the + and – buttons under Diameter.
When the Diameter value is correct, you are done inputting measurements.
16. Lower the Hood; the Wheel spins briefly.
17. When the Wheel stops, lift the Hood.
18. Check the value on the Inner Window.
– If the value is 00, you do not need to add weight to the Inner Edge or the Inner Plane.
– If there is a value—.25, for example—you need to add that amount of Weight to the Inner
Edge or the Inner Plane.
19. To add Weight, break off the appropriate number of Adhesive Weight sections.
20. Turn the Wheel, watching the indicators under the Inner Window.
The Indicators light up or go out as you move the Wheel.
21. When all of the Indicators go on, press the Brake Pedal to hold the Wheel at that position.
22. Pull the backing off the Adhesive Weights, then add the Weight at Top Dead Center on the Wheel
(12 o'clock high) on the Inner Edge or the Inner Plane, as appropriate for the ALU Mode.
If you are adding Adhesive Weight with multiple sections, center them on Top Dead Center.
DST30P Wheel Balancer
35
P/N 5900163 — Rev. C1 — March 2020