Ranger DST30P Installation And Operation Manual page 13

Unpacking
Use caution when unpacking the Balancer from its shipping container. You do not want to damage the
unit, misplace any of the components that come with it, or hurt anyone.
⚠
CAUTION
We recommend you unpack the Balancer in the area where you are going to set it up.
To unpack the Balancer:
1. Make sure you are wearing OSHA-approved (publication 3151) Personal Protective Equipment:
leather gloves, steel-toed work boots, ANSI-approved eye protection, back belts, and hearing
protection.
2. Remove the carton by flipping down the metal tabs
over the top of the Balancer.
Use care removing the carton; it is awkward and may change shape when moved.
3. Remove the plastic wrap, cardboard pieces, and other shipping components.
4. Remove the shipping bolts holding the Balancer to the Pallet.
5. Lean the Balancer over and reach underneath it to
6. Move the Balancer off the Pallet, then move it to the desired location.
Important:
⚠
CAUTION
DST30P Wheel Balancer
Make sure to use an appropriate lifting device, such as a Forklift or Pallet Jack, to
move the Balancer while it is on its pallet. Make sure only personnel who are
experienced with material handling procedures are allowed to move the Balancer.
The Balancer is heavy and the weight is not evenly distributed; dropping or
knocking over the unit may cause equipment damage or personal injury. Do not lift
the Balancer by the Shaft Housing; you will damage it.
Do not lift the Balancer by the Shaft Housing; it is not strong enough to bear the
weight of the Balancer.
Ranger recommends having at least two people move the Balancer; it is heavy. If it
is dropped or falls, it could cause injuries and/or the Balancer could be damaged.
at the bottom
pull out the Accessory Box
13
P/N 5900163 — Rev. C1 — March 2020
and pulling it off the Pallet,
.