Nortel Meridian 1 Hardware Replacement Manual page 7

About this document
Who should use this document
How this document is organized
This document applies to Meridian 1 Internet Enabled systems.
This document is a global document. Contact your system supplier or your
Nortel Networks representative to verify that the hardware and software
described is supported in your area.
This document tells you how to replace hardware in Meridian 1 systems.
This document is intended for individuals responsible for system
maintenance.
In this manual, "replacing hardware" means removing a faulty piece of
equipment and installing identical operating equipment. The procedures in
this document are based on the assumption that the system is properly
installed (for example, all card locations, option switch settings, and cable
connections are correct) and was fully operational before the hardware fault.
To use this document, you should have a basic knowledge of Meridian 1
maintenance procedures. Generally, only common tools (such as socket
wrenches, screwdrivers, and pliers) are required to perform these procedures.
This document does not provide procedures for locating and clearing faults.
See Fault Clearing (553-3001-510) to locate and clear faults.
Page 7 of 250
Hardware Replacement