Nortel Meridian 1 Hardware Replacement Manual page 185

Figure 26
Connector for the air probe harness
Installing equipment
1 Install the replacement air probe harness:
a. Gently push the air probe into the clip holder.
b. Route the air probe wiring on the perforated panel. At the rear
edge of the panel, route the wires with wiring for the thermostat
harness. Secure loose cabling to the perforated panel with cable
ties.
c. Turn the perforated panel over. Slide it slightly to the right (at the
rear of the column) so it is in a secure position. Position wiring
from the perforated panel so it rests in the cable well next to the
orange connector at the rear of the module (see Figure 27 on
page 185).
Figure 27
Routing the air probe harness from the top cap
Top of
module
d. Insert the orange connector into the right-angle bracket at the top
of the module. Simultaneously push the four small snaps on the
connector to insert it.
2 Install the top cap and perforated panel:
Replacing equipment
Push here
Orange connector
Push here
Cable well Orange connector
View at rear of module
Page 185 of 250
553-5888
Bracket
553-5889
Hardware Replacement