Replacing an NT7D10 PDU with an
NT7D67CB PDU
Use this procedure to replace an NT7D10 PDU with an NT7D67CB PDU in
DC-powered systems.
Note 1: The NT7D67CB PDU replaces the NT7D10 PDU. However,
both PDUs can be used in a system.
Note 2: Conduit is not required with the NT7D67CB PDU but can be
used.
Before you begin this procedure, prepare for the installation:
•
Additional wire may be required (see Step 1 on page 234).
•
An electric drill, fitted with a .234-in. metal bit must be available.
•
A Rear Mount Conduit Kit (NT7D0902) must be available
DANGER
Module covers are not hinged; do not let go of the
cover. Lift the cover away from the module and set it
out of your work area.
Page 233 of 250
Hardware Replacement