Periodic Maintenance Check; Resetting The Cycle Counter - Beckman Coulter StatSpin Express 4 M510 Instructions For Use Manual

4
Inspect the rotor for cracks or damage. Discontinue use of centrifuge if any are found
and replace the rotor. Contact Beckman Coulter at any time if the instrument is not
functioning correctly.

Periodic Maintenance Check

When the cycle counter in the instrument reaches 50,000 spins, the Error or Service
indicator will continuously illuminates. The indicator is a reminder to perform some
important maintenance inspections on the instrument. Follow these steps to complete the
maintenance inspection and reset the cycle counter.
Replace damaged or cracked components found during the inspection immediately. Contact
Beckman Coulter to order replacement parts or to schedule a repair.
1
Open the cover.
2
Turn off the power and unplug the power cord from the electrical outlet.
3
Remove protective shield and rotor from the instrument. For more information, refer to
Removing and Installing the
4
Clean the inside surfaces of the shield and bowl, as well as the rotor, with a mild
detergent.
5
Inspect the cover and housing for any cracks – particularly around the hinge area.
6
Inspect the cover gasket for tears and excessive flattening.
7
Inspect the latch guide (black) on the front of the housing for cracks.
8
Inspect the keypad for cracks or worn areas.
9
Inspect the rotor for cracks, warping, or loose hardware. For more information, refer to
Inspecting the
Do not reinstall the rotor if any are discovered.
10
Re-install the rotor and protective shield into the instrument.

Resetting the Cycle Counter

Warning
Only reset the cycle counter after conducting the recommended inspections and
service. Resetting the cycle counter without performing the recommended
inspections and service reduces the reliability and safety of the instrument.
55-006276-001CC
Rotor.
Rotor.
Maintenance
Periodic Maintenance Check
4
4-3