Mitsubishi Outlander 2015 Owner's Manual page 203

NOTE
l On vehicles equipped with M/T, the starter
will not operate unless the clutch pedal is
fully depressed (Clutch interlock).
5. On vehicles with M/T, place the gear-
shift lever in the "N" (Neutral) position.
On vehicles with A/T or CVT, make
sure the selector lever is in the "P"
(PARK) position.
V ehicles with M/T V ehicles with A/T or CVT
6. Press the engine switch.
7. Make sure that all warning lamps are
functioning properly.
NOTE
l Minor noises may be heard on engine start-
up. These will disappear as the engine
warms up.
NOTE
l When starting the engine, you pressed the
engine switch without depressing the clutch
pedal, warning display will appear (M/T).
Warning display (colour liquid crystal dis-
play)
l When starting the engine, the selector lever
is in a position other than the "P" (PARK) or
the "N" (NEUTRAL) position, or you press-
ed the engine switch without depressing the
brake pedal, warning display will appear
(CVT).
Warning display (colour liquid crystal dis-
play)
OGFE16E1
Starting and stopping the engine
NOTE
l For the 2000 models with Auto Stop & Go
(AS&G) system, if you replace the battery, it
needs more time to start the engine in shortly
after the battery replacement.
When it is difficult to start the
engine
After several attempts, you may experience
that the engine still does not start.
1. Make sure that all electric devices, such
as lamps, air conditioning blower and
rear window demister, are turned off.
2. While depressing the brake pedal on ve-
hicles equipped with automatic transmis-
sion, CVT or the clutch pedal on the ve-
hicles equipped with manual transmis-
sion, press the accelerator pedal halfway
and hold it there, then crank the engine.
Release the accelerator pedal, immedi-
ately after the engine starts.
Starting and driving
6
6-21