Mitsubishi Outlander 2015 Owner's Manual page 269

NOTE
l Set speed adjustment is impossible while the
accelerator pedal is in a depressed position.
To decrease the set speed
There are two ways to decrease the set speed.
By using the "SET -" switch:
The set speed decreases by 1 km/h (1 mph)
every time you push down the "SET -"
switch while the ACC control is working. If
you hold the switch pushed down, the set
speed decreases in increments of 5 km/h
(3 mph).
NOTE
l There is some time lag between the setting
to a new speed and actually decelerating to
that speed.
NOTE
l If there is a vehicle in front and your vehicle
is following that vehicle at a speed lower
than the set speed, the set speed alone de-
creases with no actual deceleration taking
place.
l
When the switch is held pushed, a buzzer
sounds every time the set speed changes.
CAUTION
l The setting speed should be set up the suita-
ble speed according to a situation.
By using the brake pedal:
If you depress the brake pedal while the ACC
control is working, the control is cancelled,
allowing you to decelerate the vehicle.
At the point where the vehicle slows down to
your desired speed, push down the "SET -"
switch; the new speed is then set in the sys-
tem.
OGFE16E1
Adaptive Cruise Control System (ACC)*
NOTE
l The ACC control is cancelled if you depress
the brake pedal and the ACC control does
not resume even when you release the pedal.
To temporarily accelerate the
vehicle
Simply depress the accelerator pedal to tem-
porarily accelerate the vehicle. Releasing the
pedal automatically slows down the vehicle
to the set speed and the ACC restarts its con-
trol.
CAUTION
l The ACC braking control and proximity
alarm functions will not work while the ac-
celerator pedal is depressed.
l The setting speed should be set up the suita-
ble speed according to a situation.
Starting and driving
6
6-87