Mitsubishi Outlander 2015 Owner's Manual page 351

Cancelling
There are two cancel functions.
If you are at the main menu, say "Cancel" to
®
exit from the Bluetooth 2.0 interface.
If you are anywhere else within the system,
say "Cancel" to return to the main menu.
Confirmation function setting
®
The Bluetooth 2.0 interface is equipped
with a confirmation function.
With the confirmation function activated, you
are given more opportunities than normal to
confirm a command when making various
®
settings to the Bluetooth 2.0 interface. This
allows you to decrease the possibility that a
setting is accidentally changed.
The confirmation function can be turned on
or off by following the steps below.
1. Press the SPEECH button.
2. Say "Setup".
3. Say "Confirmation prompts".
4. The voice guide will say "Confirmation
prompts are <on/off>. Would you like to
turn confirmation prompts <off/on>".
Answer "Yes" to change the setting or
answer "No" to keep the current setting.
5. The voice guide will say "Confirmation
prompts are <off/on>" and then the sys-
tem will return to the main menu.
Security function
E00760200011
It is possible to use a password as a security
function by setting a password of your choice
®
for the Bluetooth 2.0 interface.
When the security function is turned on, it is
necessary to make a voice input of a 4-digit
password in order to use all functions of the
®
Bluetooth 2.0 interface, except for recep-
E00760400013
tion.
Setting the password
Use the following procedure to turn on the
security function by setting a password.
1. Press the SPEECH button.
2. Say "Setup".
3. Say "Password."
4. The voice guide will say "Password is
disabled. Would you like to enable it?"
Answer "Yes."
Answer "No" to cancel the setting of the
password and return to the main menu.
5. The voice guide will say "Please say a 4-
digit password. Remember this pass-
word. It will be required to use this sys-
tem".
Say a 4-digit number which you want to
set as a password.
6. For confirmation purposes, the voice
guide will say "Password <4-digit pass-
E00760500229
word>. Is this correct?" Answer "Yes."
Answer "No" to return to the password
input in Step 5.
7. When the registration of the password is
completed, the voice guide will say
"Password is enabled" and the system
will return to the main menu.
l
l
Entering the password
If a password has been set and the security
function is enabled, the voice guide will say
"Hands-free system is locked. State the pass-
word to continue" when the SPEECH button
is pressed to enter voice recognition mode.
Say the 4-digit password number to enter the
password.
OGFE16E1
Bluetooth® 2.0 interface*
NOTE
Password will be required to access the sys-
tem after the next ignition cycle.
It is required for a little time after engine
stop that the entered password is actually re-
corded in the system.
If the ignition switch or the operation mode
is made to ACC or ON or the engine is star-
ted immediately after engine stop, there is a
case when the entered password is not recor-
ded in the system. At this time, please try to
enter the password again.
For pleasant driving
7
7-53