Second Seats - Mitsubishi Outlander 2015 Owner's Manual

CAUTION
l Operate in the high position for quick heat-
ing. Once the seat is warm, set the heater to
low to keep it warm. Slight variations in seat
temperature may be felt while using the
heated seats. This is caused by the operation
of the heater's internal thermostat and does
not indicate a malfunction.
l If the following types of persons use the
heated seats, they might become too hot or
receive minor burns (red skin, heat blisters,
etc.):
• Children, elderly or ill people
• People with sensitive skin
• Excessively tired people
• People under the influence of alcohol or
sleep inducing medication (cold medicine,
etc.)
l Do not place heavy objects on the seat or
stick pins, needles, or other pointed objects
into it.
l Do not use a blanket, cushion, or other mate-
rial with high heat insulation properties on
the seat while using the heater; this might
cause the heater element to overheat
l Do not use benzine, kerosene, petrol, alcohol
or other organic solvents when cleaning the
seats. Doing so could damage not only the
seat cover, but also the heater element.
l If water or any other liquid is spilled on the
seat, allow it to dry thoroughly before at-
tempting to use the heater.
l Turn the heater off immediately if it appears
to be malfunctioning during use.

Second seats*

1- To adjust forward or backward (vehicles
with second seat slide function)
Lift the handle and adjust the seat to the
desired position, and release the handle.
2- To recline the seatback
Pull the lever up and adjust the seatback
by hand to the desired position, and re-
lease the lever.
Armrest
To use the armrest, fold it down.
OGFE16E1
To return to the original position, push it
backward level with the seat.
E00402001426
NOTE
l Do not climb or sit on the armrest.
Doing so could damage the armrest.
l The top surface of the armrest contains a cup
holder for second seat occupants.
Refer to "Cup holder" on page 7-80.
To get in and out of the third
seat
E00402400423
(walk-in function, 7 persons)
The lever can be used to make getting in and
out easier. Pull up the lever (A), tilt the seat-
back forward. Then slide the entire seat for-
ward.
To return the seat, slide the entire seat back-
ward to the desired position and then raise
the seatback until it locks securely.
Seats and seat belts
Second seats*
4
E00412600053
4-05