Important Instructions On Use; Appropriate Use; Introduction; Areas Of Use And Application - Bosch Rexroth IndraControl L10 Project Planning Manual

Project Planning Manual | Rexroth IndraControl L10
2

Important Instructions on Use

2.1

Appropriate Use

2.1.1

Introduction

WARNING
2.1.2

Areas of Use and Application

Rexroth products represent state-of-the-art developments and manufacturing.
They are tested prior to delivery to ensure operating safety and reliability.
Physical and property damage due to the inappropriate use of products!
The products are designed for their use within the industrial environment and
may therefore only be used for the intended purpose. If the use is inappropriate,
situations causing physical damage as well as property damage can occur.
Rexroth disclaims as manufacturer any warranty, liability or for
damages occurring due to inappropriate use of the products. Fur‐
thermore, Rexroth is not paying any compensation. The user is
responsible for any risks resulting from the products not being used
as intended.
Before using Rexroth products, the following pre-requisites must be fulfilled to
ensure an appropriate use of the products:
● Anyone handling one of the Rexroth products in any way has to read and
understand the respective safety instructions as well as the instructions
on the appropriate use.
● Hardware products have to remain in their original state, in other words,
no modification regarding the design are allowed. Software products may
not be decompiled and their source codes may not be modified.
● Damaged or faulty products are not to be implemented or put into opera‐
tion.
● It is to be ensured that the corresponding products are installed according
to the specifications of the documentation.
The Steuerung IndraControl L10 of Rexroth is suitable for logic applications.
It can be necessary to connect additional sensors and actuators to control and
monitor the IndraControl L10.
The IndraControl L10 may only be used with the accessories and
add-on components specified in this documentation. Components
that are not named explicitly may neither be mounted nor connec‐
ted. Same is applicable for cables and wires.
Operation my only be carried out in the configurations and combi‐
nations of the components specified and with the software and
firmware determined in the respective functional description.
Each drive control device has to be programmed before commissioning so that
the motor carries out the specific functions for the application.
Typical areas of application of the IndraControl L10:
● Handling systems and assembly systems
● General automation tasks
Electric Drives | Bosch Rexroth AG
and Controls
Important Instructions on Use
3/54