Digital Outputs - Bosch Rexroth IndraControl L10 Project Planning Manual

30/54 Bosch Rexroth AG | Electric Drives
Connections and Interfaces
7.3.3

Digital Outputs

and Controls
Input current:
Nominal value for "0"
Nominal value for "1"
Delay time:
for "0" after "1"
for "1" after "0"
Current consumption by 24 V supply (U
Cable length (unshielded)
Interrupt inputs
Sensor supply
Output voltage
Nominal current (total)
Short-circuit protection, overcurrent protection
Criteria for connecting 2-wire proximity switches:
Quiescent current
Voltage drop
Fig.7-14: Data of digital inputs
Light-emitting diodes indicating the current state of the inputs are arranged on
the top of the input terminals.
LEDs 1, 2, 3, 4 Meaning
Off The assigned input is not set.
Yellow The assigned input is set.
Fig.7-15: Status LEDs of digital inputs
An additional two-color light-emitting diode (identified by D) emits green light in
case the 24 V voltage is present and red light in case of a short-circuit or over‐
load.
Light-emitting diode Meaning
D
Off 24 V voltage is missing.
Green 24 V voltage is present.
Red Short-circuit or overload.
Fig.7-16: Light-emitting diode D
Two terminal strips with a total of 4 digital outputs are arranged between the
digital inputs and the terminals for the voltage supply.
Slots 3:
Rexroth IndraControl L10 | Project Planning Manual
)
S
< 2.5 mA
2.8 mA ... 6 mA
Type 50 μs
Type 50 μs
Typ. 60 mA
< 100 m
8
From U via a PTC
S
fuse
Type Uext. – 1 V
0.2 A
Typ. 0.6 A
< 2.5 mA
< 6 V