Table of Contents
Advertisement
36/54
Bosch Rexroth AG | Electric Drives
Installation and Maintenance
Removing the IndraControl from
the top-hat rail
8.2
Electric Installation
8.2.1
General Information
DANGER
8.2.2
External Power
and Controls
If any of the modules is provided with more connectors than one,
all these connectors must be removed from the module.
●
Pry out the connector of the module to be removed by pressing on the rear
connector shaft latch.
●
Remove the connector(s).
●
Remove the power connector from the IndraControl L10. This ensures that
the feathers of the voltage jumpers and the keyway/feather key connection
are prevented from damage. Moreover, the module can be accessed more
easily.
●
Actuate the release mechanism (1 in figure
the electronic socket perpendicularly to the top-hat rail (2 in figure
page
36).
Fig.8-1:
Before dismounting the IndraControl L10, the first Rexroth Inline module
must be removed.
Actuate the release mechanism and remove the control from the mounting rail.
The following rules for setting up a system, in which the electrical equipment
like control systems are used, must be adhered to:
●
DIN VDE 0100
●
DIN EN 60 204-1
●
DIN EN 50 178
Danger of personal injury and material damage!
Any dangerous states of the system which might cause personal injury or ma‐
terial damage must be prevented!
The rules and regulations for setting up EMERGENCY STOP equipment in
accordance with EN 60 204-1 must be adhered to!
Any automatic restart of machines after power return, e. g. after an EMER‐
GENCY STOP, must be excluded!
Protection for direct and indirect contact must be ensured by the measures
prescribed (connection to protective conductor, isolation, etc.).
All components of the IndraControl L10 are supplied with 24 V supply voltages.
Rexroth IndraControl L10 | Project Planning Manual
8-1 on page
36) and remove
8-1 on
Hide quick links:
Advertisement
Table of Contents
