Table of Contents
Advertisement
Project Planning Manual | Rexroth IndraControl L10
DANGER
Dangerous movements! Danger to life, risk of injury, severe bodily harm
or material damage!
●
Ensure personal safety by means of qualified and tested higher-level
monitoring devices or measures integrated in the installation.
These measures have to be provided for by the user according to the
specific conditions within the installation and a hazard and fault analysis.
The safety regulations applicable for the installation have to be taken into
consideration. Unintended machine motion or other malfunction is possi‐
ble if safety devices are disabled, bypassed or not activated.
To avoid accidents, bodily harm and/or material damage:
●
Keep free and clear of the machine's range of motion and moving parts.
Possible measures to prevent people from accidentally entering the
machine's range of motion:
–
use safety fences
–
use safety guards
–
use protective coverings
–
install light curtains or light barriers
●
Fences and coverings must be strong enough to resist maximum possible
momentum.
●
Mount the emergency stop switch in the immediate reach of the operator.
Verify that the emergency stop works before startup. Don't operate the
device if the emergency stop is not working.
●
Isolate the drive power connection by means of an emergency stop circuit
or use a safety related starting lockout to prevent unintentional start.
●
Make sure that the drives are brought to a safe standstill before accessing
or entering the danger zone.
●
Additionally secure vertical axes against falling or dropping after switching
off the motor power by, for example:
–
mechanically securing the vertical axes,
–
adding an external braking/ arrester/ clamping mechanism or
–
ensuring sufficient equilibration of the vertical axes.
●
The standard equipment motor brake or an external brake controlled di‐
rectly by the drive controller are not sufficient to guarantee personal
safety!
●
Disconnect electrical power to the equipment using a master switch and
secure the switch against reconnection for:
–
maintenance and repair work
–
cleaning of equipment
–
long periods of discontinued equipment use
●
Prevent the operation of high-frequency, remote control and radio equip‐
ment near electronics circuits and supply leads. If the use of such devices
cannot be avoided, verify the system and the installation for possible mal‐
functions in all possible positions of normal use before initial startup. If
necessary, perform a special electromagnetic compatibility (EMC) test on
the installation.
Electric Drives
| Bosch Rexroth AG
and Controls
Safety Instructions for Electric Drives and Controls
11/54
Hide quick links:
Advertisement
Table of Contents
