Commissioning; Communication And Configuration - ABB TTH300 Operating Instruction

6

Commissioning

The transmitter is immediately ready for operation after mounting and installation of the
connections. The parameters are set at the factory.
The connected lines must be checked for firm seating. Only firmly seated lines ensure full
functionality.
K
7

Communication and configuration

Important
Transmitter communication and configuration via HART, PROFIBUS PA, and FOUNDATION
Fieldbus H1 are described in separate documentation ("Interface description").
The following configuration types are available for the transmitter:
• With DTM
Configuration can be performed within an FDT frame application that is approved for use
with the DTM.
• With EDD
Configuration can be performed within an EDD frame application that is approved for use
with the EDD.
• Via type A LC display with control buttons
Configuration can be performed using the four control buttons on the front.
Important
Unlike configuration using the DTM or EDD, the functionality of the transmitter can only be
changed to a limited extent if the LC display is used.
OI/TTH300-EN TTH300
Commissioning
29