AMP Research Power Step 76331-01A Installation Manual page 9

A M P R E S E A R C H P O W E R S T E P
Connect the two purple wires coming from under the
passenger side to the two wires in the engine com-
partment. Use Posi locks to connect them.
Note: Connect the matching wire color/stripe.
19
Pull down carpet on dash lower/center on
the driver side and pull the tube through from
passenger side. Note: When feeding tube
thru, make sure to position it under exist-
ing wire harness (see picture) to keep the
wires away from the silver AC/Heater tubing
as that part may get hot and cause damage
to wires. Once the tube is fed thru, feed both
purple wires thru the tubing tool.The tube can
now be pulled off.
21
Feed wires thru the under dash cover as shown to keep wires tucked up out of the way. Connect the OBD II
plug to the trigger wires with Posi Lock Connector (14). Connect the matching wire color/stripe.
22
www.amp-research.com
– D O D G E D U R A N G O
T M
Now, feed the tube (25) thru the lower/center of the
dash.
14
25
20
9/13
Keep wires away AC/Heater Tube
14
IM76331 rev 8.10.18