AMP Research Power Step 76331-01A Installation Manual page 5

A M P R E S E A R C H P O W E R S T E P
Installing Linkages
When installing linkages, use the second and fourth set of bolt holes on the pinch weld (see be-
low).
Front of vehicle
Driver side shown
1
Rear Linkage (Without Motor)
Note: Remove existing bolt from fuel tank strap bolt and install
linkage with Hex Bolt (21).
Install the rear linkage assembly to rearmost pinch weld holes and
fuel tank strap bolt hole. Tighten up fuel tank strap bolt (21) just
enough for bracket hole to line up with pinch weld holes. Snug Hex
bolt (11) and black washers (13) to bracket holes.
passenger side shown
2
www.amp-research.com
2nd set (aprox 16")
– D O D G E D U R A N G O
T M
4th Set (aprox 66")
5/13
Driver Side
Passenger Side
Direction of brackets on
rear linkages, driver and
passenger side.
IM76331 rev 8.10.18