MOGlabs ARF021 Manual page 121

C.9 Table mode
111
start stop count duration
from to in steps, each lasting . In simple
count
table mode this generates table entries, whereas in advanced
table mode it generates up to three.
SAVE
TABLE,SAVE,ch,slot
slot
Save the current table in a FLASH memory slot, where is a num-
ber from 1 to 4. Uploading tables in binary format is also possible
using the mogrf host software.
LOAD
TABLE,LOAD,ch,slot
Loads the table from the specified slot in FLASH memory to the
designated channel.
DUMP
TABLE,DUMP,ch
Prints the table for the specified channel in binary for later upload.
The command should not be used from an interactive terminal and is
provided for automation purposes. The response begins with a 32-
bit unsigned integer that contains the number of bytes in the table,
which is the number of bytes to be subsequently read. Note that
raw table data may be incompatible between different firmware
versions.
SYNC
TABLE,SYNC[,onoff]
Enable or disable table synchronisation mode (see §8.8), which sets
CH1 as a "master" table and CH2 as a "slave" table. Both tables
execute then simultaneously when CH1 is started.
TRIGSYNC
TABLE,TRIGSYNC[,onoff]
Enable or disable DE15 trigger synchronisation between the two
channels, which causes CH2 to take its DE15 trigger from CH1 . This
option is a more precise equivalent of wiring the two inputs together.
NORESET
TABLE,NORESET,ch[,onoff]
Disables table-mode phase reset for the specified channel. Nor-
mally the DDS phase accumulator is reset when the table is started,
ensuring that the output waveform has the same starting phase for