Upgrade Via Web Interface - MOGlabs ARF021 Manual

B.4 Upgrade via web interface
B.4 Upgrade via web interface
A web interface was used in early firmware versions to upgrade the
microcontroller. It should only be used when a factory reset reverts
the firmware to a version that does not support mogrffw.
1. Connect power and ethernet.
2. Set DIP1 to ON
3. The LCD screen should display **FW UPDATE MODE** and the
IP address of the unit, which may be different to the IP address
in normal operation.
4. Use a web browser and connect to the specified IP address.
5. At the prompt, enter your user ID and password. These are
user-configurable but by default are
6. Select Browse and then select the microcontroller firmware
file. The required file is a .bin file inside the firmware .zip
file, beginning with B3010 and including either R2 (for
hardware), or R3 (for
correct file is uploaded; do not select the file marked "
Upload
7. Click on
8. The LCD display will indicate when the process is complete.
9. Reset DIP1 to
10. Once the microcontroller has been upgraded, it will be neces-
sary to then upgrade the
If you encounter any difficulties, please get in touch with
There is a low-level "
these tools fail, but this should only be attempted after consultation.
and switch on the device.
moglabs
UserID:
agilerf
Password:
R 3 +). It is very important that the
.
OFF and power-cycle the unit.
firmware using mogrffw.
FPGA
DFU " protocol which can be used in the event
97
R 2
".
IAP
MOGL abs.