Nikon Epiphot 300 Manual page 17

• Plug one end (socket) of the power cable into
the AC IN connector of the power supply unit.
Insert the other end (plug) of the cable into an
AC IN LINE receptacle.
g
C® Control Box
• The battery chamber cover is on the bottom of
the control box. Move this cover in the arrow
direction to detach it. Set the voltage
selection switch at the available line voltage.
• Load the Ni-Cd battery (3.6V-50mAH) as per
the polarity indication(+,-) in the battery
chamber, and re-attach the battery chamber
cover.
Bottom of the control box
�,,,,.,,
Ni-Cd battery
�
Do not dispose of used or disused batteries.
Return them to your nearest Nikon
representative.
Turn off the power switch of the control box
before connecting the cables.
• Connect the control box to the microscope
base with the signal cable. Push the plug
insertion/detaching button of the signal cable
connector to insert the plug of the signal cable
straight into the receptacle matching its
direction with the receptacle.
• Insert the end of the DX cable from the
microscope base into the connector of the
control box.
• Insert one end (socket) of the power supply
cable into the AC..l:N connector of the control
box. Insert the other end (plug) of the cable
into an AC IN LINE receptacle.