Nikon Epiphot 300 Manual page 14

Loosen the clamp screw on the side of the
lamphouse cover with a coin or the like [I], and
detach the cover [21.
Press down the lamp clamp lever. While
pressing it down, insert the lamp into the socket
until the lamp pins reach the limits in the
pinholes (�and � ). Be careful not to tilt the
lamp when releasing the clamp lever.
Put the cover back, and tighten the clamp screw
on the cover.
Sufficiently loosen the lamphouse clamp screw
on the lamphouse adapter. Insert the lamphouse
into the adapter until it reaches the limit. Tighten
the clamp screw with the centering tool.
I � ,,,
I�
I
I
@ Revolving Nosepiece
Sufficiently loosen the nosepiece clamp screw
with the hexagonal screwdriver. Fit the circular
dovetail of the nosepiece to the corresponding
mount in the microscope base. Ensuring that the
outer circumference of the nosepiece's dovetail is
in contact with the claws on the mount, tighten
the clamp screw with the supplied centering tool.
© Stage
• The stage attachment base of the microscope
has two pins. Place the stage onto the
attachment base so that the two pins fit into
the pinhole and the groove on the bottom of
the stage plate. Tighten the three screws
supplied with the stage. Use the hexagonal
wrench to tighten these screws. If the stage is
fixed in the opposite direction, the stage
movement knobs are located at the front left.
(Note that the figure shows the stage
movement knobs are located at the rear right.)
• Fit the stage ring onto the stage. Screw in the
two specimen clips on the stage.
I
)>
en
en
m
s:
ID
�
6