Table of Contents
Advertisement
Installation
Pressure Transducer Installation
Refer to the appropriate section of the PLLD Site Prep manual (P/N 576013-902) for transducer installation in the
Leak Detector Port (see Figure 15).
I.S. Barrier Installation
If an I.S. Barrier is being installed, refer to the appropriate section of the VSFC Site Prep manual (P/N 577013-
815) for installation instructions (refer to Figure 15 for installation port).
Tubing Kit Installation
1. Remove and set aside the cover of the contractor's box over the wiring entry compression bushing (refer to
Figure 15).
Contractor's box cover
(access to wiring entry
compression bushing
Contractor's box cover
(Install I.S. Barrier in
this port if used)
2. If necessary loosen the two screws in the top of the compression bushing until you can lift it out of the
manifold(see Figure 16).
Figure 15. VSFC Component Installation Ports
18
Pressure Transducer Installation
Leak Detector port
(Pressure Transducer)
rjpumps/fig29.eps
Advertisement
Table of Contents
Need help?
Do you have a question about the Quick-Set VSFC Submersible Turbine Pump and is the answer not in the manual?
Questions and answers