Table of Contents
Advertisement
If the SCSI hard disk drive that is installed in SCSI connector 2 is part of a RAID array,
delete this SCSI RAID array configuration before removing the hard disk drive. When you
delete the RAID array, the array configuration information is removed; no data is deleted.
There are two types of I/O expansion cards supported by the blade server:
•
Gigabit Ethernet expansion card
•
Fibre Channel expansion card
The Gigabit Ethernet and Fibre Channel expansion cards are available as a small form-factor card
and a standard form-factor card.
The following sections describe how to install an I/O expansion card in the blade server.
NOTE
You cannot install both sizes of I/O expansion cards in the same blade server. You can install
the small form-factor expansion card in addition to having two SCSI hard disk drives, but
you cannot install a standard form-factor expansion card into a blade server with two SCSI
hard disk drives.
Installing a small form-factor expansion card
The small form-factor expansion option is installed near SCSI connector 2.
Complete the following steps to install the small form-factor expansion card:
1. Read the safety information beginning on page vii and "Installation guidelines" on page 17.
2. Shut down the operating system, turn off the blade server, and remove the blade server from the
SBCE unit (see "Removing the blade server from the SBCE unit" on page 19 for information).
3. Carefully lay the blade server on a flat, non-conductive surface.
4. Open the cover (see "Opening the blade server cover" on page 20 for instructions).
5. Install the small form-factor I/O expansion card:
29
Advertisement
Table of Contents
