Table of Contents
Advertisement
The Automatic TAD Transfer Timer can range from zero to 99 seconds but
is factory-preset to 30 seconds, [6] [3][0] [*]. If the timer is set to [0] or
[0][0], the ASD-4 will always TAD transfer and will not trigger RMN when a
message is received on the TAD port.
Example: To change the setting of the Automatic TAD Transfer Timer to
20 seconds, enter the programming mode and press the following on your
tone phone:
[6] Change the setting of the Automatic TAD Transfer Timer to
[2][0] The desired number of seconds
[*] End programming sequence (3 beeps indicate correct entry)
.
.
(Optional entries for additional changes)
.
[*] Save changes and exit programming
5.4.13 F
UNCTION
The RMN Phone Number function allows you to program the telephone
number that the ASD-4 dials after one or more of the RMN conditions have
been met. (See Sections 4.4 and 5.4.14 for more information.)
The RMN Phone Number function is capable of storing a telephone
number up to 16 digits long. It has no factory-preset value.
Example: To enter a number to be dialed—for the purposes of this
example, 1 (303) 555-6789—when an RMN condition is triggered, enter the
programming mode and press the following on your tone phone:
[7] Set the RMN Phone Number to
[1] [3][0][3] [5][5][5] [6][7][8][9] The desired phone number
[*] End programming sequence (3 beeps indicate correct entry)
.
.
(Optional entries for additional changes)
.
[*] Save changes and exit programming
[7]: RMN P
HONE
CHAPTER 5: Programming the ASD-4
N
UMBER
59
Advertisement
Table of Contents
