Table of Contents
Advertisement
5.3.5 F
[4]: P
EATURE
The Pulse Transfer feature allows rotary/pulse dialing extension phones that
are directly or indirectly connected to the ASD-4's TAD and PHONE ports
(see Section 3.5) to transfer calls to the FAX or MODEM ports. The Pulse
Transfer feature is factory-preset ON, [1] [4] [*].
Example: To turn the Pulse Transfer feature OFF, enter the programming
mode and press the following on your tone phone:
[0] Turn OFF
[4] Pulse Transfer
[*] End programming sequence (3 beeps indicate correct entry)
.
.
(Optional entries for additional changes)
.
[*] Save changes and exit programming
5.3.6 F
[5]: A
EATURE
The Automatic No Answer Transfer feature enables the ASD-4 to route a call
that is actively ringing the TAD and PHONE ports to either the FAX or
MODEM port. The setting of feature [1][2], Automatic Transfer Port
Selection, determines where the call goes after the TAD and PHONE ports'
ring count expires.
The Automatic No Answer Transfer feature is factory-preset ON, [1] [5] [*].
Turn this feature OFF if you want the ASD-4 to hang up without defaulting to
the FAX or MODEM port.
Example: To turn the Automatic No Answer Transfer feature OFF, enter
the programming mode and press the following on your tone phone:
[0] Turn OFF
[5] Automatic No Answer Transfer
[*] End programming sequence (3 beeps indicate correct entry)
.
.
(Optional entries for additional changes)
.
[*] Save changes and exit programming
T
ULSE
RANSFER
N
A
UTOMATIC
O
NSWER
CHAPTER 5: Programming the ASD-4
T
RANSFER
45
Advertisement
Table of Contents
